![background image](http://html1.mh-extra.com/html/magnetek/rcp/rcp_user-manual_3581075014.webp)
RCP User’s Guide
July 2017
Page 14 of 110
When the “Add” button is clicked you will see a pop-up that prompts the user for what data is to be read
from the device.
If you hover over the check box or text a tooltip will appear detailing the data that will be transferred from
the device to the RCP project. Clicking “Cancel” will close the pop-up, will not transfer any data, and the
project will open with default values. The following explains what is transferred when each of these boxes
are checked.
Unit Info
– The information located on the Unit Info tab in the unit info panel located on the left hand side
of the tab page. The project ID is the only parameter not sent from this group when the “Unit Info” box is
checked. The project ID will be sent/read when the application or programming data is transferred.
CAN Configuration
– The source address, protocol, baud rate, identifier and terminating resistor.
Application Data
– For transmitters, this includes input configuration, feedback and the project ID. For
receivers, the transfer includes the project ID and programming data.
When the “Continue” button is clicked you will see a pop-up that shows the progress of reading the device
data. When the reading is complete click “Close” to continue.
5.1.2 Opening an Existing Project
Select “Open Project…” if you want to retrieve an existing program file. A list of recent projects also
appears under the Recent Project Files. Clicking on one of these will open that project. It is recommended
that you create a folder in which to save all programming files. When opening an existing project the user
interface will automatically navigate to the last page that was visible when the project was saved.
CAUTION
TO PROGRAM OR READ DATA FROM THE DEVICE, THE DEVICE MUST BE TURNED ON AND CONNECTED VIA
USB.
An existing project can be opened and modified without a device being connected. Doing this permits a
program to be modified offline and a device programmed at a later time.
Содержание RCP
