![background image](http://html1.mh-extra.com/html/magnetek/rcp/rcp_user-manual_3581075016.webp)
RCP User’s Guide
July 2017
Page 16 of 110
Figure 1: Screen Capture of the FDP Tab Page
NOTE: If you navigate away from the FDP tab page and the device has been restarted but is not showing
in the device list, try clicking the “Discover Devices” button
located in the upper left hand corner of the
tab page.
NOTE: When programming the device is complete, the device firmware is verified through FDP. This
increases the amount of time it takes to complete the programming step.
WARNING
THE USER IS RESPONSIBLE FOR LOADING THE CORRECT FIRMWARE ON THE DEVICE. DEVICE BEHAVIOR
IS UNKNOWN IF THE WRONG FIRMWARE IS LOADED ON THE DEVICE. LOADING FIRMWARE FOR ANOTHER
TYPE OF DEVICE CAN CAUSE THE DEVICE TO BE INOPERABLE.
5.2.2.1
Steps to Load Firmware
The configuration settings of the unit should be read from the device and saved prior to changing
the firmware.
o
Refer to Section 5.3.2 for information on how to read from the device.
o
Refer to Section 5.2.1 for information on how to save the project.
Click the “Reset Device” button to put the device in to bootloader mode.
o
Putting the device in bootloader mode allows firmware to be loaded on the device.
o
Once the device is reset the other buttons will be enabled.
o
The text area will be updated with the status of the reset.
Section 1: Warning and Error
messages are displayed here.
Section 2: Logging area. Shows
information related to programming
the device.
Section 3: Shows the number of
devices attached.
Содержание RCP
