![background image](http://html1.mh-extra.com/html/magnetek/rcp/rcp_user-manual_3581075100.webp)
RCP User’s Guide
July 2017
Page 100 of 110
Crane Configuration Properties
Description
Group Coding Enabled
GROUP CODE DIFFERS FROM MULTIBOX IN THAT THE
ACCESS CODES DO NOT HAVE TO BE SEQUENTIAL.
Group code capability allows up to 8 transmitters to access a
single receiver on a first come, first served basis. Only one
transmitter may control the receiver at a given time. Once a
transmitter has gained control, another transmitter may not
access the receiver until the controlling transmitter relinquishes
control by transmitting an OFF command to the receiver or the
receiver times out due to inactivity.
WARNING
IF YOU NEED TO ADD GROUP CODE OR ADD ADDITIONAL
TRANSMITTERS PLEASE CONTACT MAGNETEK FOR
ASSISSTANCE WITH THIS FEATURE. FAILURE TO FOLLOW THIS
WARNING COULD RESULT IN SERIOUS INJURY OR DEATH AND
DAMAGE TO EQUIPMENT.
Checking the group code box will bring up a pull-down to select
the number of access codes the receiver should accept, from 1
to 7. Note that the mini help will be displayed at the bottom of the
screen for each option as the mouse hovers over it.
Transmitters
The number of additional transmitters used with group coding.
Access Code
The access codes for the transmitters; 2-8.
Tandem Enabled
Enable/disable tandem operation.
Invert
This feature is only for custom crane relay configurations using
select relays. Turning this switch ON (1) reverses the select
function operation so that the opposite relay closes for the
selected function. This feature is most commonly used on
European hoists.
Inactivity Timer Enabled
The receiver has a 15-minute timeout timer. If a receiver once
turned ON by a transmitter does not receive a signal from any
transmitter for a period of 15 minutes the receiver shuts down
and opens the main line. Unchecking this box disables this
feature.
EMS Alarm Output
Gives about five seconds of alarm when the Emergency Stop
(ESTOP) is activated on the transmitter. This also allows the
alarm button to function in the ESTOP mode. Check if desired.
Auto Alarm
Auto Alarm closes the alarm relay for about five seconds when
the receiver is first turned on.
Button Order
Through this feature the conventional arrangement of transmitter
motion switch pairs (Hoist [H] at the top, Trolley [T] in the middle,
and Bridge [B] at the bottom) can be changed without rewiring
the receiver. To change simply select the desired order from the
pull-down menu.
Содержание RCP
