6-2
GPIB and RS-232C
TOS6200A/6210
6.1
Interface
This tester is provided with two interfaces: GPIB and RS-232C. If the tester is to be
remotely controlled, one of them must be used.
6.1.1
GPIB Interface
To use the GPIB interface, set a GPIB address on the tester. To set a GPIB address,
see 4.5, “Interface Setup.”
GPIB cables are available from Kikusui. Contact Kikusui distributor/agent.
GPIB cable 1 m (code: 92080)
GPIB cable 2 m (code: 92070)
GPIB cable 4 m (code: 92090)
6.1.2
RS-232C Interface
To use the RS-232C interface, make the following settings:
For settings, see 4.5, “Interface Setup.”
•
Communications rate
•
Data length
•
Parity bit
•
Stop bit
Control communication via RS-232C using flow control or acknowledgment mes-
sages. One-way transmission may make proper communication difficult. For
acknowledgment messages, see 6.2.1, "Messages.”
For an RS-232C interface cable, use a D-sub 9-pin female-female AT cross type.
Содержание TOS6200A
