Kikusui TOS6200A, Руководство пользователя

Страница: 21 / 154

TOS6200A/6210 Installation and Preparation for Use 2-7
2.4.2 Optional Test Probe LP01-TOS/LP02-TOS
• Never connect the voltage measurement cable (thin wire) of the optional
LP01/LP02-TOS test probe to the OUTPUT terminals. Its nominal sec-
tional area is inadequate for such currents, and burning may occur.
• The rated current of the LP01-TOS and LP02-TOS test probes are up to
30 A and 60 A, respectively. Do not attempt to pass a current exceeding
the rated current.
• Improper terminal connections can result in inaccurate measurements and
burns or injury resulting from heat generated by contact resistance at the
terminals.
1.
Turn off the POWER switch of the Tester.
2.
Remove the short-circuit bars connecting the OUTPUT and SAMPLING
terminals.
3.
Connect the LOW test lead to the LOW terminal of the Tester.
4.
Connect the each cable of the test probe to the HIGH and REMOTE ter-
minal of the Tester.
WARNING
To SAMPLING
HIGH terminal
Figure shows connections of the
TOS6210 with the LP02-TOS.
To the REMOTE terminal
To OUTPUT
HIGH terminal
To SAMPLING
LOW terminal
To OUTPUT
LOW terminal
TOS6210