Kikusui TOS6200A, Руководство пользователя

Страница: 138 / 154

8-4 Specifications TOS6200A/6210
8.2 Interface and Other Functions
Item Specifications
REMOTE 5-pin DIN connector on the front panel
Function An option may be connected to provide remote-controlled tester start/stop func-
tions.
Connectable options Remote controller: RC01-TOS or RC02-TOS
Test probe: LP01-TOS or LP02-TOS
SIGNAL I/O D-SUB 25-pin connector on the rear panel
For connector pin configuration, see Table 1 (attached).
Input specifi-
cations High-level input volt-
age 11 V to 15 V All input signals are controlled in active Low.
The input terminal is pulled up to +12 V with a resistor.
Leaving the input terminals open is equivalent to inputting
a high-level signal.
Low-level input volt-
age 0 V to 4 V
Low-level input cur-
rent -5 mA maximum
Input time width 5 ms minimum
Output specifi-
cations Output method Open collector output (4.5 Vdc to 30 Vdc)
Output withstand
voltage 30 Vdc
Output saturation
voltage Approximately 1.1 V (at 25

C)
Maximum output cur-
rent 400 mA (TOTAL)
RS-232C D-SUB 9-pin connector on the rear panel (compliant with EIA-232-D)
Function All functions except for the POWER switch and KEY LOCK function may be
controlled remotely.
Baud rate 9600, 19200, or 38400 bps
GPIB Complies with IEEE Std.488-1978
Function All functions except for the POWER switch and KEY LOCK function may be
controlled remotely.
For the interface function, see Table 2 (attached).
Display 240 x 64 dots LCD, which displays set values, measured values, judgment
results, and other information.
Test function AUTO Performs testing (maximum 100 steps) under different test conditions.
MAIN Performs a single earth continuity test.
Memory function AUTO Provides programming of up to 100 different tests, each consisting of a maxi-
mum of 100 steps. (Note that the total number of steps is 500.)
MAIN 100 maximum
Backup battery life 3 years or more (at 25

C)
TEST MODE PASS HOLD Allows a PASS judgment to be held for a specified holding time.
MOMENTARY Allows testing only while the START switch is pressed.
FAIL MODE Disables cancellation of FAIL or PROTECTION status using a stop signal from
the remote control.
DOUBLE ACTION Allows testing only when the START switch is pressed within a half-second
after the STOP switch is released.
CONTACT CHECK Enables the tester to detect a current flowing through the output terminals to
begin testing.