Kikusui TOS6200A, Руководство пользователя

Страница: 48 / 154

4-14 Basic Operation TOS6200A/6210
4.3 Starting and Ending Test
• No test can begin when the tester is in protection status. For more information on
the protection function, see 4.10, "Protection Fuction.”
• If the STOP switch has been pressed, a test cannot be started. (This includes stop
signals sent from the remote control.)
• When DOUBLE ACTION is set to ON, you can begin the test by pressing the
STOP switch, then pressing the START switch within approximately a half-sec-
ond. Otherwise, the test cannot be started. For information on DOUBLE
ACTION, see 4.4, "System Setup.”
• When MOMENTARY is set to ON, the tester performs the test only while the
START switch is being held down. For more information on MOMENTARY, see
4.4, "System Setup.”
4.3.1 Starting a Test
To begin the test:
To begin testing, press the START switch while the MAIN screen indicates ready.
In the ready status, the upper right part of the LCD indicates “READY”.
When the test starts:
When the test starts, the LCD screen changes to display the following:
During testing, "TEST" appears in the upper right part of the LCD and the TEST
LED lights up.
The time indicated after start of the test differs with the timer function set to ON or
OFF.
When the timer is ON: The time remaining of the set time is indicated.
When the timer is OFF: The elapsed test duration is indicated.
(Note: When the time exceeds 999 seconds, “999”
blinks.)
NOTE
CURRENT LOWER UPPER TIMER
25.0
A
0.002 60.0
s
MAIN MAIN
FREQ LOWER OFF OFFSET OFF TIMER ON
READY
50Hz
LOWER
DISP
1.4
s
MAIN MAIN
FREQ LOWER OFF OFFSET OFF TIMER ON
TEST
60Hz
3.00
V
25.0
A
0.120
NORM