GE HEALTHCARE CARESCAPE Monitor B450, Техническое руководство

Страница: 141 / 236

Maintenance and checkout
133
2062973-003
−
Analog output cable (2000633-001)
NOTE: You can alternatively use the GE defib sync tester, 2040582-001, together with the
Analog output cable, 2000633-001 and a multiparameter simulator to perform this test. Follow
the instructions included with the tester. See analog output cable wire colors and related
signals from the table below.
Connecting cables
1. Ensure that the module is connected to the patient monitor.
2. Connect the 5-lead ECG trunk cable to the green ECG connector in the module.
3. Connect the 5-leadwire sets to the trunk cable and to the simulator.
4. Connect the invasive pressure adapter cable to the simulator and the other end to the
module.
5. Connect the analog output cable to the defibrillation synchronization connector in the
patient monitor.
6. Connect the open wires of the other end of the analog output cable to the oscilloscope
probe as described in each test. Use the figure and table below as a reference for making
the connections.
*) Brown wire is not connected.
Configuring the monitor
1. Configure ECG:
a. Select ECG1 to the screen with waveform and adequate priority.
b. In the Parameter Setup > ECG > Setup , select ECG1 Lead: II.
2. Configure invasive pressure:
a. Select P1 to the screen with waveform and adequate priority.
b. In the Parameter Setup > Invasive Pressures > P1 , select:
−
Label: P1.
Defibrillation synchronization connector Related wire color in the open
end of the Analog output cable
*)
Pin number Signal
1 Digital defibrillator synchronization
marker out signal Black
2 Digital defibrillator synchronization
marker in signal Green
3 Common GND Red
4 Analog GND Blue
5 Analog GND White
6 IP analog output Yellow
7 ECG analog output Grey