Extreme Networks EPICenter 6.0, Справочное руководство

Страница: 531 / 580

SNMP Trap Events
EPICenter Reference Guide
531
OSPF Originate LSA An ospfOriginateLsa trap signifies that a new LSA has been
originated by this router. This trap should not be invoked for
simple refreshes of LSAs (which happens every 30 minutes),
but instead will only be invoked when an LSA is (re)originated
due to a topology change. Additionally, this trap does not
include LSAs that are being flushed because they have reached
MaxAge. ExtremeWare 6.1.9
ExtremeXOS 10.1
OSPF TX_Retransmit An ospfTxRetransmit trap signifies than an OSPF packet has
been retransmitted on a non- virtual interface. All packets that
may be retransmitted are associated with an LSDB entry. The
LS type, LS ID, and Router ID are used to identify the LSDB
entry. ExtremeWare 6.1.9
ExtremeXOS 10.1
OSPF Virtual Interface
Authentication Failure An ospfVirtIfAuthFailure trap signifies that a packet has been
received on a virtual interface from a router whose
authentication key or authentication type conflicts with this
router’s authentication key or authentication type. ExtremeWare 6.1.9
ExtremeXOS 10.1
OSPF Virtual Interface
Config Error An ospfVirtIfConfigError trap signifies that a packet has been
received on a virtual interface from a router whose configuration
parameters conflict with this router’s configuration parameters.
Note that the event optionMismatch should cause a trap only if
it prevents an adjacency from forming. ExtremeWare 6.1.9
ExtremeXOS 10.1
OSPF Virtual Interface
Receive Bad Packet An ospfVirtIfRxBadPacket trap signifies that an OSPF packet
has been received on a virtual interface that cannot be parsed. ExtremeWare 6.1.9
ExtremeXOS 10.1
OSPF Virtual Interface
State Change An ospfVirtIfStateChange trap signifies that there has been a
change in the state of an OSPF virtual interface. This trap
should be generated when the interface state regresses (e.g.,
goes from Point- to-Point to Down) or progresses to a terminal
state (i.e., Point-to-Point). ExtremeWare 6.1.9
ExtremeXOS 10.1
OSPF Virtual Interface
TX Retransmit An ospfVirtIfTxRetransmit trap signifies than an OSPF packet
has been retransmitted on a virtual interface. All packets that
may be retransmitted are associated with an LSDB entry. The
LS type, LS ID, and Router ID are used to identify the LSDB
entry. ExtremeWare 6.1.9
ExtremeXOS 10.1
OSPF Virtual Neighbor
State Change An ospfVirtNbrStateChange trap signifies that there has been a
change in the state of an OSPF virtual neighbor. This trap
should be generated when the neighbor state regresses (e.g.,
goes from Attempt or Full to 1-Way or Down) or progresses to a
terminal state (e.g., Full). ExtremeWare 6.1.9
ExtremeXOS 10.1
Overheat Extreme Networks proprietary trap. Indicates the on board
temperature sensor has reported an overheat condition. This
indicates the temperature has reached the Overheat threshold.
The switch will continue to function until it reaches its
shutdown threshold. The system will then shutdown until the
unit has sufficiently cooled such that operation may begin
again. A cold start trap will be issued when the unit has come
back on line. This trap is sent repetitively every 30 seconds
until the temperature goes back to normal. All
Ping Probe Failed Generated when a probe failure is detected when the
corresponding pingCtlTrapGeneration object is set to
probeFailure(0) subject to the value of
pingCtlTrapProbeFailureFilter. The object
pingCtlTrapProbeFailureFilter can be used to specify the
number of successive probe failures that are required before
this notification can be generated. ExtremeWare 6.1.9
Not supported in
ExtremeXOS
Table 58: SNMP Trap Events (continued)
Event Definition
ExtremeWare/
ExtremeXOS
Version