Endress+Hauser SpectraSensors SS2000e, Руководство оператора

Страница: 90 / 114

NS 5.14 Firmware
3
–
30 4900002262 rev. B 3-23-21
• Validation Allowance : Sets the tolerance (±%) for validation
measurements when Val 1 Concentration or Val 2 Concentration is set
to a value greater than 0.
•
Validation Wait Time : Sets the amount of time (in seconds) for the
validation gas to purge the system at the beginning of the validation.
•
Val Perm Constant Kp : Sets the system constant for the perm
tube.
•
Val Perm Rate Rp : Sets the calibrated permeation rate for the perm
tube.
•
Val Purge Period : Sets the number of seconds upon validation
initiation that a differential analyzer will purge the system with
validation gas before starting a dry cycle.
• Val Start Time : Sets the hour of the day for the daily autovalidation
to begin.
• Val Time : Time of last validation.
•
Wet Pressure (mb) : Current measured (live) wet pressure reading
of the gas sample in millibar (mb).
•
Wet Temp (C) : Current measured (live) temperature of the gas
sample in degrees Celsius.
•
Zero Val Tolerance : Sets the maximum acceptable reading (in
ppmv) when validating with zero gas (Val 1 Concentration = 0 or Val
2 Concentration = 0).
• Zero Level : Signal level when the laser is turned off.