Endress+Hauser Liquiline System CA80NO, Руководство по эксплуатации

Страница: 61 / 172

Liquiline System CA80NO Operation
Hauser 61
• Logbook name
Assign a name. Example: "01".
• Source of data
Select a data source. Example: Signal of binary input 1.
• Measured value
Select the measured value to be recorded. Example: pH value.
• Scan time
Specify the time interval between two logbook entries.
• Data logbook
Activate the logbook: specify the data storage method.
2. ../ Finished : Perform the action.
 The device shows the new logbook in the list of data logbooks.
3. Select data logbook "01".
 Additional display: Log time left .
4. Only in the case of Fill up buffer :
Decide to set Overflow warning : On or Off .
 On : The device displays a diagnostic message in the event of memory overflow.
5. Line plotter submenu: Specify the type of graphic representation.
10.2.5 Advanced setup
Diagnostics settings
The list of diagnostic messages displayed depends on the path selected. There are device-
specific messages, and messages that depend on what sensor is connected.
Menu/Setup/(General settings or Inputs<Sensor channel>)/Extended setup/Diagnostics settings/Diag.
behavior
Function Options Info
List of diagnostic messages
‣
Select the message to be changed. Only then
can you make the settings for this message.
Diag. code Read only
Diagnostic message Selection
• On
• Off
Factory setting
Depends on the message
You can deactivate or reactivate a diagnostic
message here.
Deactivating means:
• No error message in the measuring mode
• No error current at the current output
Failure current Selection
• On
• Off
Factory setting
Depends on the message
‣
Decide whether an error current should be
output at the current output if the diagnostic
message display is activated.

In the event of general device errors, the
error current is output at all the current
outputs. In the event of channel-specific
errors, the error current is only output at
the assigned current output.
Status signal Selection
• Maintenance (M)
• Out of specification (S)
• Function check (C)
• Failure (F)
Factory setting
Depends on the message
The messages are divided into different error
categories in accordance with NAMUR NE 107.
‣
Decide whether you want to change a status
signal assignment for your application.