Emerson 2130 RBM Consultant Pro, Справочное руководство

Страница: 34 / 394

2-14 Setting Up and Using Laser Alignment Fixtures
After the Fast charging cycle has completed, the charger’s beeper sounds and the
charger automatically begins trickle charging. When this condition begins, the
Trickle indicator light turns on indicating that the battery is almost completely
charged, or is completely charged. For the laser head batteries, the two conditions
occur within a few minutes of each other. Charge time from a fully discharged set
of batteries to approximately a 90% voltage charge is 45 minutes (current version
of the 8211 charger) and 15 minutes for the former version of the 8211 Charger.
If the Discharge cycle has been initiated, on completion the charger automatically
begins fast charging and the Fast indicator light turns on. If charging a former ver-
sion of the laser heads that contain NiCad batteries - to avoid the battery memory
concern use the Discharge mode when you have more than 20 minutes to charge
the sensor head batteries. The typical charge cycle is as follows:
Note
After power has been applied to the charger and the sensor head(s)
placed in it, if none of the LED's for that sensor head are lit then the
contact between the sensor head and charger may not be sufficient
to charge the batteries. No LED's lit indicates a “no battery present”
state. If this takes place, remove the sensor head from the charger and
try reseating it back into the charger.
Action Time
Press DISCHARGE button Start
DISCHARGE complete, FAST starts 7 minutes
FAST complete, TRICKLE starts – charging complete 22 minutes
NOTE: The heads can be left on TRICKLE indefinitely (until the next time they are
needed).