Emerson 2130 RBM Consultant Pro, Справочное руководство

Страница: 120 / 394

3-40 Horizontal Alignment
Edit Equip ID
Use the Edit Equip ID key to edit the Equipment ID. This option is useful for iden-
tifying the equipment being aligned. The Equipment ID is displayed in the upper
section of the main screen (for the active job). The Equipment ID can be a max-
imum of 10 characters.
Edit Equip Desc
Use the Edit Equip Desc key to edit the Equipment Description. This option is
useful for adding additional information to identify the equipment being aligned.
The Equipment Job Description can be a maximum of 28 characters.
Edit Area
Use the Edit Area key to edit the Area Description. This option is useful for identi-
fying where the equipment being aligned is located. The Area Description can be
a maximum of 32 characters.
Edit Coupling Number
Use the Edit Coupling Number key to edit the Coupling Number. This option is
useful if the machinery being aligned has more than one coupling. Each coupling
should have a unique number. An example would be a machinery train consisting
of a motor, a gearbox, and a compressor. The coupling between the motor and
gearbox should be 1 and the coupling between the gearbox and compressor
should be 2. The Coupling Number must be in the range 1 (default) to 10.
Set Mode
Use the Set Mode key to toggle the alignment mode of the job between horizontal
(default), vertical, and straightness. Refer to the appropriate sections for informa-
tion about these modes.
The job mode is displayed:
• in the upper section of the main screen (for the active job),
• in the center of the Job Manager screen (for all jobs listed).
If you attempt to change the job mode after the job has been created, a warning
messge displays asking if this is the operation to be performed. If accepted, the
alignment mode of the job is changed.
• any changes made to the job setup will be cleared,