Emerson 2130 RBM Consultant Pro, Справочное руководство

Страница: 292 / 394

4-6 Vertical Alignment
Vertical Main Screen Function Keys
Enter Dimensions
Use the Enter Dimensions key to advance to the Edit Dimensions screen where the
dimensions for the machine being aligned can be entered. This is the first step of
the three-key operation used in performing an alignment job. Refer to the Vertical
Enter Dimensions section on page 4-17 for more information.
Sweep Laser Heads
Use the Sweep Laser Heads key to advance to the data acquisition screen for the
alignment method defined for the job. This is the second step of the three-key
operation used in performing an alignment job. From this screen alignment data
needed to determine the alignment condition of the machine is acquired. Refer to
the Vertical Sweep Laser Heads section on page 4-29 for more information.
Move Machine
Use the Move Machine key to advance to the Angular Move screen where the
angular alignment condition can be reviewed. This is the third step of the three-key
operation used in performing an alignment job. After the Angular Move screen,
the program advances to the Offset Move screen where the machine moves can be
reviewed. If an alignment correction is necessary that requires a live move, this can
also be done from under this step. Refer to the Vertical Move Machine section on
page 4-38 for more information.
Note
The Enter key will perform the same function as the soft key for the
highlighted program step. In addition, the Enter key can be used to
advance you through an alignment job from beginning-to-end using
the job parameters setup on the Alt Main screen.