Emerson 2130 RBM Consultant Pro, Справочное руководство

Страница: 129 / 394

3-49 Laser Address Selection
Refer to the following table for a description of each dimension.
Note
The dimensions are the same for both the Model 8215 and the
Model 8225 laser heads.
Note
With large equipment, you may need to drop a plumb bob from the
laser head to measure these dimensions accurately.
Dimension Measurement Description
Measure
to the
Nearest
A Center of outboard foot to center of inboard foot of the
machine on the left. 1/8 inch
(3 mm)
B Center of inboard foot on the left machine to the laser head
face on the left machine. To enter a measurement for a foot
that falls inside the laser face, place a negative sign (–) in front
of it. 1/8 inch
(3 mm)
C Measure from the inside face of one laser head to the inside
face of the other laser head. 1/16 inch
(1.5 mm)
D Center of inboard foot on the right machine to the laser head
on the right machine. To enter a measurement for a foot that
falls inside the laser face, place a negative sign (–) in front of
it. 1/8 inch
(3 mm)
E Center of outboard foot to center of inboard foot of the
machine on the right. 1/8 inch
(3 mm)
F From right laser head to center of coupling or, to the location
where offset tolerances are measured (this is not required for
jackshaft tolerances). To enter a measurement where the
center of the coupling falls outside or behind a laser face,
place a negative sign (-) in front of the measurement. 1/8 inch
(3 mm)