Emerson 2130 RBM Consultant Pro, Справочное руководство

Страница: 259 / 394

3-179 Laser Address Selection
The alignment condition is displayed just below the machine graphics. Depending
on the analyzer units, since the tolerance type can only be Standard when per-
forming a C-face alignment the alignment angle data displayed will be in mils/inch
or milliradian (mrad) while offset data displayed will be in mils or millimeters
(mm).
The bull’s-eye target displayed just below the coupling represents the alignment
condition with respect to the tolerances defined for the job. If the tolerance condi-
tion is greater than 2 times the acceptable tolerance, then the outer band will be
red. If the tolerance condition is 1 to 2 times the acceptable tolerance, then the
middle band will be yellow. If the tolerance condition is less than the acceptable tol-
erance, but greater than the excellent tolerance, then the center band (bull’s-eye)
will be green. If the tolerance condition is less than the excellent tolerance, then the
center band will have a black star displayed in it. Refer to the Tolerances section on
page 3-193 for more information.
The amount of movement required to align the machine (expressed in either mils
or millimeters (mm), depending on the analyzer units) is displayed just to the right
of the flange. A graphical representation of the movement (represented by the
dual arrows) is displayed in the center of the flange.
Shim values are equivalent to raising the machine. In this case, all shim values will
be positive. When correcting angular misalignment keep the flange offset move-
ment to a minimum. After shimming is complete, be sure to re-tighten bolts and
take a new set of readings.
C-face Setup key
Use the C-face Setup key to return to the C-face Setup screen.
Enter key
Use the Enter key to advance to the Main screen.