Dasan V8102, Руководство пользователя

Страница: 753 / 910

User Manual
UMN:CLI
V8102
753
disable } [GPON] tion.
To configure ONU deactivation monitoring, use the following command.
Command Mode Description
olt deactive-monitor alarm-raise
<1-99>
Interface
[GPON]
Sets the deactive ONU-raise percent.
1-99: (default: 30%)
olt deactive-monitor alarm-
clear <1-99>
Sets the deactive ONU-clear percent. If the current
percent becomes higher than this value, the alarm
status changes to off.
1-99: (default: 70%)
olt deactive-monitor period <10-
86400>
Sets the deactive ONU monitoring period. If the current
percent is higher than a alarm-raise percent, the alarm
is off and the current percent changes to 100% after a
period.
10-86400: deactive ONU monitoring period (default: 10
seconds)
no olt deactive-monitor alarm-
raise
Deletes the configured value of deactive ONU monitor-
ing parameters.
no olt deactive-monitor alarm-
clear
no olt deactive-monitor period
To display the configuration of ONU deactivation monitoring, use the following command.
Command Mode Description
show olt deactive-monitor [ gpon
OLT-ID ]
Enable
Global
Shows the configuration of ONU deactivation monitor-
ing.
show olt deactive-monitor
Interface
[GPON]
To clear the alarms of ONU deactivation monitoring, use the following command.
Command Mode Description
clear olt deactive-monitor alarm
Interface
[GPON]
Clears the collected alarms by ONU deactivation moni-
toring.
13.1.20 OLT Bit Error Ratio (BER)
You can configure the monitor direction and the alarm threshold of the bit error ratio. The
system generates a bit error ratio (BER) alarm when the total number of error bits or bit
error rate of the data transferred between the OLT and ONUs exceeds the alarm thresh-
old. Both uplink and downlink data between OLT and ONU can be monitored.
To configure the OLT Bit Error Ratio (BER), use the following command.