UMN:CLI
User Manual
V8102
752
13.1.18
Configuring Port/TCONT Threshold
When one GPON port is connected to a lot of ONTs with T-CONTs and GEM ports, you
can specify the maximum numbers (threshold) of T-CONTs and GEM port count. So that
an alarm is generated if a given threshold is exceeded.
To configure the threshold of GEM port count, use the following command.
Command
Mode
Description
olt threshold port
<1-3966>
Interface
[GPON]
Sets the threshold of GEM port count for ONT.
1-3966 : threshold value
no olt threshold port
Deletes the configured threshold of GEM port.
To configure the threshold of dynamic / fixed T-CONT count for ONT, use the following
command.
Command
Mode
Description
olt threshold tcont dynamic
DYNAMIC_VALUE
[
fixed
FIXED_VALUE
]
Interface
[GPON]
Sets the threshold of Dynamic/Fixed T-CONT count for
ONT.
DYNAMIC_VALUE: 1 to 384
FIXED_VALUE: 1 to 384
olt
threshold
tcont
fixed
FIXED_VALUE
[
dynamic
DY-
NAMIC_VALUE
]
no olt threshold tcont
{
dynamic
|
fixed
}
Deletes the configured threshold of T-CONT count.
To display the configuration of GEM-port/ T-CONT threshold, use the following command.
Command
Mode
Description
show olt threshold port
[
gpon
OLT-ID
]
Enable
Global
Shows the configured GEM-port/ T-CONT count
threshold of ONTs.
show olt threshold tcont
[
gpon
OLT-ID
]
show olt threshold port
Interface
[GPON]
show olt threshold tcont
13.1.19
ONU Deactivation Monitoring
ONU deactivation monitoring function generates alarms based on ONU (ONT)
’s deactiva-
tion. The system calculates the current percentage by the number change of active ONUs
every hour. If the number of active ONU is reduced and the current percent is lower than
a given alarm-raise percent, the deactive monitor alarm is on. If the current percent ex-
ceeds the configured alarm-clear percent, the deactive monitor alarm changes to off.
To enable/disable ONU deactivation monitoring, use the following command.
Command
Mode
Description
olt deactive-monitor
{
enable
|
Interface
Enables/disables ONU deactivation monitoring func-
Содержание V8102
Страница 1: ...1 V8102 GPON OLT system User Manual...
Страница 158: ...UMN CLI User Manual V8102 158 When you use the no snmp command all configurations of SNMP will be lost...
Страница 427: ...User Manual UMN CLI V8102 427 show debugging dhcp Enable Global Shows the debugging information of DHCP...
Страница 797: ...User Manual UMN CLI V8102 797 show onu gsp status config ONU_ID tag list number TAG_NAME tag name...