Dasan V8102, Руководство пользователя

Страница: 800 / 910

UMN:CLI
User Manual
V8102
800
To configure a polling interval and count for rogue ONT, use the following command.
Command Mode Description
rogue onu polling [<10-60000>
<1-250>]
ONU-Profile
Specifies a polling interval and count for rogue ONT.
10-60000: polling interval value (unit: millisecond)
1-250: polling count
rogue onu polling disable Deletes the specified polling interval and count.
To enable/disable the alarm for rogue ONU and specify the alarm count that is the maxi-
mum number of retransmission of alarms in case of no response from OLT, use the fol-
lowing command.
Command Mode Description
rogue onu alarm enable <1-5>
ONU-Profile
Enables the alarm after detecting a rogue ONU.
1-5: alarming count
rogue onu alarm disable Disables the alarm after detecting a rogue ONU.
To set the waiting time for OLT
’s response, use the following command.
Command Mode Description
rogue onu waiting-time <100-
50000>
ONU-Profile
Sets the waiting time for OLT
’s response
100-50000: waiting time (unit: millisecond)
rogue onu waiting-time disable Deletes the specified waiting time for OLT
’s response.
13.3.2.3 Card Type Configuration
You need to select a card type in case that ONT is provided with the configurable circuit
pack (e.g., T1/E1). To set a card type on the configurable circuit pack, use the following
command.
Command Mode Description
circuit-pack card-config c-ds1-
e1 { ds1 | e1 }
ONU-Profile
Selects a card type on the configurable circuit pack.
c-ds1-e1: Configurable DS1/E1 module
c-ds1-e1-j1: Configurable DS1/E1/J1 module
circuit-pack card-config c-ds1-
e1-j1 { ds1 | e1 | j1 }
no circuit-pack card-config { c-
ds1-e1 | c-ds1-e1-j1 }
Deletes the configuration of card type on the configu-
rable circuit pack.
13.3.2.4 Loop Detect Configuration
A loop may occur when double paths are used for the link redundancy between switches
and one sends unknown unicast or multicast packet that causes endless packet floating
on the LAN. That superfluous traffic eventually can result in network fault.
The V8102 provides the function to configure the ONU
’s loop detecting. The loop detect-
ing mechanism is as follows: