Dasan V8102, Руководство пользователя

Страница: 218 / 910

UMN:CLI
User Manual
V8102
218
meg NAME trust-member-count
COUNT
COUNT: the trust member port count value
no ethernet oam uplink-
redundancy meg NAME trust-
member-count
Deletes the configured trust LOC count.
7.7.20.8 Hold Off Time
When a link failure occurs, the nodes start Hold off timer. The nodes do not change their
uplink link state until a hold off timer expires, to ensure that while the fault still exists, a
link failure state is maintained. To specify hold-off time, use the following command.
Command Mode Description
ethernet oam uplink-redundancy
meg NAME hold-off-time <0-
10000>
Global
Configures the hold-off time
0-10000: hold-off time (default: 100ms, unit: millisec-
ond)
To configure hold-off time as the default, use the following command.
Command Mode Description
no ethernet oam uplink-
redundancy meg NAME hold-off-
time
Global Configures the hold-off time as default value
7.7.20.9 Wait-to-Restore Time
If an uplink port
’s link failure is recovered on the revertive mode, the forwarding/blocking
status of uplink ports is not changed right after the recovery, the nodes wait the given
wait-to-restore time.
To specify a wait-to-restore time, use the following command.
Command Mode Description
ethernet oam uplink-redundancy
meg NAME wait-to-restore <10-
720>
Global
Configures wait-to-restore time.
10-720: Wait to restore time in second (default:5s)
To delete the configured wait-to-restore time, use the following command.
Command Mode Description
no ethernet oam uplink-
redundancy meg NAME wait-to-
restore
Global Deletes the configured wait-to-restore time.