Centaur 2001 950, Руководство по обслуживанию, Страница: 63 / 450

Centaur Service Manual Engine System
Ontario Drive & Gear Limited. www.centaur8x8.ca
(519) 662-2840 FAX (519) 662-2421
EN-39
14 . Replug the green starter relay wire back into the relay. Photo EN-88
15. Reconnect the trigger coil wiring at the plug.
Photo EN-89
.
EN-87 EN-88
EN-89
EN-90
This wiring is for ignition timing, as well as the pickup for the tachometer on the gas model .
On the diesel model , this wiring reads the impulse for the tachometer rpm’s only. Blue
connects to the orange/black stripe of the engine harness, and green connects to brown of
the harness.
16. Connect the wiring to the alternator. Fasten the 6 gauge eye terminal at the alternator
post and cover with the rubber boot. Plug the yellow, and the black/yellow stripe wire
into the alternator. Photo EN-90
Blue Wire to #3 coil (terminal closest to firewall) then yellow ignition wire. Orange
wire to #2 coil (terminal closest to firewall) then yellow ignition wire. Red wire to the
#1 coil (terminal closest to firewall) then yellow ignition wire. Photo EN-83
10. On the
diesel
model engine, reconnect the preheat wire (Red) and light indicator sen-
sor wire ( white/red stripe) to the top of the glow plugs as in Photo EN-84
11. Isolate the conduit sleeving with the purple wire, which connects to the oil pressure
switch. Slip the green wire from the fuel shutoff switch on the carburetor, through this
same conduit and connect at the main engine harness.
Photo EN-85
12 . Reconnect the purple/white stripe wire to the oil pressure switch. Photo EN-86
13. Connect the 6 gauge power wire at the starter post and cover with the rubber boot.
Photo En-87