Centaur 2001 950, Руководство по обслуживанию, Страница: 252 / 450

Steering System Centaur Service Manual
Ontario Drive & Gear Limited www.centaur8x8.ca
(519) 662-2840 FAX (519) 662-2421
ST-16 ST-16
The other end of the steering lock system is located at the steering lever assembly on the
hydrostatic pump. This consists of a spring loaded locking pin mounted to a bracket on the
upper frame cross brace assembly. When the arm rest is in the upper position, the pin protrudes
through a lock slide plate, preventing the steering lever from moving in either direction.
6. The locking slide plate is mounted to the steering lever at the hydrostatic pump by 2
bolts. To remove the plate, unfasten both bolts. Photo ST-42
ST-41 ST-42
Assembling the Steering Lock Cable to the Bracket
Assemble the cable to the bracket at the pump referring to
Photo-ST-42(a) & 42(b)
ST-42(b)
Adjusting the Steering Lock Pin
To disconnect or adjust the spring pin end of the cable, remove or loosen the 2 fasteners
securing the bracket to the welded tab on the upper cross brace assembly. Slide the bracket
until approximately 1/8” protrudes through the locking slide plate when the armrest is in
the upright position.
Photo ST-43
ST-42(a)