Centaur 2001 950, Руководство по обслуживанию, Страница: 110 / 450

Electrical System Centaur Service Manual
ES-26
Ontario Drive & Gear Limited www.centaur8x8.ca
(519) 662-2840 FAX (519) 662-2421
Electrical System Centaur Service Manual
The tachometer is initially calibrated at the factory during production, but if for some reason
it needs to be re-calibrated or replaced with a new one, these procedures must be followed to
achieve the correct RPM readout from the engine which powers the CENTAUR vehicle.
The Tachometer may be set while installed in the vehicle, however you need to access the back
of it to press the setting control contact, which may prove easier if the dash is unfastened.
1. Connect 12 Volts DC to the dash ( if the dash is removed). Photo ES-34
2. Using a small screwdriver or pin, press and hold the control setting contact in the back
of the tachometer while turning the ignition key to the on position. Watch the front of
the tach until the LED reads PULSE, then release immediately. Photo ES-35,36 &
37
Calibrating the Tachometer
ES-34 ES-35
ES-36 ES-37