Centaur 2001 950, Руководство по обслуживанию, Страница: 38 / 450

Engine System Centaur Service Manual
Ontario Drive & Gear Limited www.centaur8x8.ca
(519) 662-2840 FAX (519) 662-2421
EN-14
fuel flows from filter.
4. Tighten drain plug. Bleed air from fuel line.
5. Start engine. Make sure warning light goes out. Check for leaks.
To replace fuel filter element:
1. Disconnect sensor wire. Remove drain plug and discard O-ring.
2. Remove fuel filter with filter wrench.
3. Screw new filter on by hand until gasket contacts housing. Then tighten 1/3 turn
more.
4. Install drain plug with new O-ring. Connect sensor wire.
5. Bleed air from fuel line. Start engine and check for leaks.
Do not operate the fuel injector pump dry. Ensure the pump is primed with fuel before
starting to prevent damage to the pump.
Engine Oil Filter
During the initial engine break-in period, change the oil filter when the oil is changed. After
that, change the oil filter every 300 hours.
Before installing the new filter, lubricate the rubber filter gasket with fresh oil. Screw the filter
on by hand until the gasket contacts filter adapter. Tighten 1/2 to 3/4 turn more. Start and
run engine to check for oil leaks. Stop engine and re-check oil level. Add oil if required.
Spark Plugs (Gas Engine)
Remove and inspect the spark plugs after every 150 hours of operation. Clean the plugs
and reset the gap as detailed in the engine owner’s manual.
Replace the spark plugs if the electrodes are corroded or damaged or if the insulator is
cracked. Use the correct plug for the engine as detailed in the engine owner’s manual.
Re-install the spark plugs carefully, taking care to start the threads properly. Torque the
plugs to 10 - 15 ft. lbs (14 to 20 N·m). Do not over tighten.