Bull NovaScale R460 E2, Руководство пользователя, Страница: 63 / 490

General Description 2-29
IMPORTANT: If a noisy sound in driving the optical disk drive occurs after setting a disc, set it
again correctly.
To take out the disc from the optical disk drive, press the Eject button in the similar way in setting the disc to make the tray go
out.
If the access LED is lit, the disc is being accessed. Confirm that the access LED is not lit before pressing the Eject button.
As shown in the figure below, hold the tray with a hand and take the end of the disc lightly by the fingers of another hand with
the suppression of the rotor at the center of the tray to remove the disc from the tray.
After taking out the disc, return the tray into the drive.
When you fail to eject the tray with the Eject button and take out the disc from the server, follow the procedure below.
Emergency hole
1.
Press the POWER switch to power off the server. (The POWER LED goes off.)
2.
Insert a metal pin of approximately 1.2 mm in diameter and 100 mm in length (a straightened large paper clip will
make a substitute) into the emergency hole on the right front of the optical disk drive and gently push it in until the
tray is ejected.
IMPORTANT:
„
Do not use a toothpick or plastic stick that is easy to break.
„
If the above procedure does not let you take out the disc, contact your service representative.
3.
Hold the tray and pull it out.
4.
Take out the disc.
5.
Push the tray back into position.