Bull NovaScale R460 E2, Руководство пользователя, Страница: 259 / 490

Troubleshooting 8-5
Error
code Error message
Recommended Action
0B6A CPU2_DIMM5 has been disabled
0B6B CPU2_DIMM6 has been disabled
0B70 The error occurred during temperature
sensor reading. Contact your service representative.
0B71 System Temperature out of the range. Contact your service representative to replace the fan.
0B74 The error occurred during voltage sensor
reading.
0B75 System voltage out of the range.
Contact your service representative.
0B80 BMC Memory Test Failed.
0B81 BMC Firmware Code Area CRC check
failed.
0B82 BMC core Hardware failure.
0B83 BMC IBF or OBF check failed.
Turn off the power once and then on again to start the server. If the
error cannot be corrected, contact your service representative.
0B8A BMC SEL area full Clear the system event logs by using the BIOS SETUP utility (see
Chapter 4).
0B8B BMC progress check timeout.
0B8C BMC command access failed.
0B8D Could not redirect the console - BMC Busy -
0B8E Could not redirect the console - BMC Error -
Turn off the power once and then on again to start the server. If the
error cannot be corrected, contact your service representative.
0B8F Could not redirect the console - BMC
Parameter Error -
0B90 BMC Platform Information Area corrupted.
0B91 BMC update firmware corrupted.
Turn off the power once and then on again to start the server. If the
error cannot be corrected, contact your service representative.
0B92 Internal Use Area of BMC FRU corrupted. This is not a fatal error. Turn off the power once and then on again to
restart the server. If the error cannot be corrected, contact your service
representative.
0B93 BMC SDR Repository empty. Turn off the power once and then on again to restart the server. If the
error cannot be corrected, contact your service representative.
0B94 IPMB signal lines do not respond. This is not a fatal error. Turn off the power once and then on again to
restart the server. If the error cannot be corrected, contact your service
representative.
0B95 BMC FRU device failure. This is not a fatal error. Turn off the power once and then on again to
restart the server. If the error cannot be corrected, contact your service
representative.
0B96 BMC SDR Repository failure.
0B97 BMC SEL device failure.
0B98 BMC RAM test error.
0B99 BMC Fatal hardware error.
Turn off the power once and then on again to start the server. If the
error cannot be corrected, contact your service representative.
0B9A BMC not responding. Update the RMC firmware. If the error cannot be corrected, contact
your service representative.
0B9B Private I2C bus not responding.
0B9C BMC internal exception.
0B9D BMC A/D timeout error.
0B9E SDR repository corrupt.
0B9F SEL corrupt.
Turn off the power once and then on again to start the server. If the
error cannot be corrected, contact your service representative.
0BB0 SMBIOS – SROM data read error.
0BB1 SMBIOS – SROM data checksum bad.
Contact your service representative.
8068 Unsupported Processor Speed detected on
CPU Slot 1. Contact your service representative.
8069 Unsupported Processor Speed detected on
CPU Slot 2.
8160 Mismatch Processor Type/Speed detected
on Processor 1.
8161 Mismatch Processor Type/Speed detected
on Processor 2.
Contact your service representative.