Bull NovaScale R460 E2, Руководство пользователя, Страница: 48 / 490

2-14 General Description
does not indicate a failure.) When a failing hard disk drive is replaced in RAID System, the system automatically
rebuilds the data. (Auto-rebuild function) The LED switches back and forth between green and amber during rebuild
processing.
The LED goes off when the rebuild processing has terminated. It turns amber when the rebuild processing fails.
IMPORTANT:
If the server is turned off during rebuild processing, the processing is stopped.
Restart the server, mount the new hard disk drive in hot swap mode, and then perform rebuild
processing again. Observe the following notes on using the auto-rebuild function.
„
Do not turn the power off. (Once the power is turned off, the auto-build function does not
start.)
„
Let 90 seconds or more pass between when dismounting a failing hard disk drive and when
mounting the new one.
„
Do not replace a failing hard disk drive while rebuild processing is being performed for another
hard disk drive.
LAN Connector LEDs
There are two LEDs for each of the three LAN ports (connectors) on the rear panel.
Speed
LED
LINK/ACT
LED
LINK/ACT
LED
Speed
LED
Speed
LED
LINK/ACT
LED
Data transmission
ports
Management
port
„
LINK/ACT LEDs
Each LINK/ACT LED indicates the status of the standard network port of the server. While power is supplied to the
server and HUB and the connection is correct, the LED is on (green). The LED turns green and flashes while the
network port is transmitting/receiving data.
If the LED does not go on when the LINK state is placed, check if the network cable is in normal state and if it is
connected correctly. If the LED does not go on yet when the network cable is normal, the network (LAN) controller
may be faulty. In this case, contact your service representative.
„
Speed LEDs (for data transmission ports)
This LED indicates whether each of the network ports normally equipped with the server is operated through the
1000BASE-T, 100BASE-TX or 10BASE-T network interface. If the LED is lit amber, the network port is operated
through 1000BASE-T. If the LED is lit green, the network port is operated through 100BASE-TX. If the LED is off,
the network port is operated through 10BASE-T.
„
Speed LED (for management port)
This LED indicates whether each of the network ports normally equipped with the server is operated through the
100BASE-TX or 10BASE-T network interface. If the LED is lit green, the network port is operated through
100BASE-TX. If the LED is off, the network port is operated through 10BASE-T.