Bull NovaScale R460 E2, Руководство пользователя, Страница: 262 / 490

8-8 Troubleshooting
On-screen message Action
Some configured disks have been removed from your
system, or are no longer accessible. Please check your
cables and also ensure all disks are present.
Press any key to continue, or 'C' to load the configuration
utility.
The following VDs have missing disks: xx
If you proceed (or load the configuration utility), these VDs
will be marked OFFLINE and will be inaccessible.
Please check your cables and ensure all disks are present.
Press any key to continue, or 'C' to load the configuration
utility.
The following VDs are missing: xx
If you proceed (or load the configuration utility), these VDs
will be removed from your configuration. If you wish to use
them at a later time, they will have to be imported. If you
believe these VDs should be present, please power off your
system and check your cables to ensure all disks are present.
Press any key to continue, or 'C' to load the configuration
utility.
All of the disks from your previous configuration are gone. If
this is an unexpected message, then please power off your
system and check your cables to ensure all disks are present.
Press any key to continue, or 'C' to load the configuration
utility. Check if cable and hard disk drives are connected properly.
If the same error persists, contact your service
representative.
The cache contains dirty data, but some VDs are missing or
will go offline, so the cached data can not be written to disk. If
this is an unexpected error,
then please power off your system and check your cables to
ensure all disks are present. If you continue, the data in
cache will be permanently discarded.
Press 'X' to acknowledge and permanently destroy the
cached data. Check if cable, hard disk drives, and upgrade kit are
connected properly. If the same error persists, contact your
service representative.
NOTE: If you press
X
, the data in cache memory will be lost.
Invalid memory configuration detected. Please contact your
system support.
System has halted. Contact your service representative to replace the RAID
controller.
RAID Adapter
FW Failed Validation!!!
Adapter needs to be reflashed.
Press any key to continue. Contact your service representative to replace the RAID
controller.
Cache data was lost due to an unexpected power-off or
reboot during a write operation, but the adapter has
recovered. This could be due to memory problems, bad
battery, or you may not have a battery installed.
Press any key to continue or 'C' to load the configuration
utility. <When battery is not used>
Run WebBIOS or Universal RAID Utility to check the setting
for cache mode. If forced write-back is specified, change it to
constant write back or write through mode.
<When battery is used>
Check if battery is connected properly.
If the same error persists, contact your service
representative to replace the RAID controller and battery.
Entering the configuration utility in this state will result in drive
configuration changes. Press 'Y' to continue loading the
configuration utility or please power off your system and
check your cables to ensure all disks are present and reboot. Contact your service representative to replace the RAID
controller.
Multibit ECC errors were detected on the controller.
DIMM on the controller needs replacement. If you continue,
data corruption can occur. Press 'X' to continue or else power
off the system and replace the DIMM module and reboot. If
you have replaced the DIMM please press 'X' to continue. Contact your service representative to replace the RAID
controller.