Bull NovaScale R460 E2, Руководство пользователя, Страница: 122 / 490

4-38 Configuring Your Server
Virtual Drives
When you click [Virtual Drives] on WebBIOS Top Menu, the screen for operating the VD that has already been configured.
List of VDs box shows existing VDs.
List of VDs
Clears the top area of the VD being selected in List of VDs box. Fast Initialize:
Clears whole area of the VD being selected in List of VDs box.
Slow Initialize:
Checks consistency in the whole area of the VD being selected in List of VDs box.
If inconsistency is found, correct it.
Check Consistency:
Displays the properties of the VD being selected in List of VDs box.
Properties:
Set Boot Drive
(Current =XX):
Selects a VD to start operating system.
If the system contains several VDs and you want to start the operating system from the VD other
than VD0, you need to specify the boot drive manually as shown below. Use the default setting in
any other cases.
Default: NONE
[Setting procedure]
1. Select a VD you want to start operating system from the List of VDs box.
2. Put a checkmark on "Set Boot Drive (Current =XX)".
3. Click [Go].
IMPORTANT:
„
If no virtual drive exists, the List of VDs box will be blank. Use this menu only when a virtual
drive exists.
„
Even the "Set Boot Drive" is properly specified, the operating system may fail to start due to
Boot Priority specified in BIOS SETUP of the server.
„
Inconsistency may be detected at the first Check Consistency performed after the VD was
configured.