Bull ESCALA PL860T/R, Процедуры снятия и замены, Страница: 49 / 218

8.
The suspended mirrored pair of the failing drive has also
failed and must be replaced.
Perform a backup of the data in the failing ASP.
Go to step 9 to replace the failing mirrored disk.
Return to the beginning of this procedure to replace the
disk that you originally intended to replace.
Note: Performing a backup is a customer task. Refer to
the system’s Operations Guide for instructions.
9.
Select Device Concurrent Maintenance from the Hardware Service Manager display. Press Enter. The Device
Concurrent Maintenance display is displayed.
1. Enter the location code of the disk drive being replaced in the form of U787A.001.AAAXXXX-P3-D4 .
2. Select option 1 (Remove device) for the Action to be performed .
3. Set the time delay for one minute: 01. Important: Do not press Enter at this time.
4. Locate the concurrent maintenance light that corresponds to the position of the disk drive that you are replacing
5. Important : When you press Enter, after a one minute delay, this light comes on and begins to blink rapidly. You
then have nine seconds to remove the disk drive.
6. Press Enter on the console.
7. When the light blinks rapidly, perform the next step to remove the disk drive within 9 seconds.
10.
Remove the disk drive by:
1. Unlock the disk drive handle by squeezing it and
pulling it out toward you as shown.
2. Support the bottom of the disk drive as you slide it
out of the system or expansion unit. Do not hold the
disk drive by the handle.
The concurrent maintenance light for the slot turns off
when you remove the disk drive.
Chapter 1. Removing and replacing FRUs
41