Bull ESCALA PL860T/R, Процедуры снятия и замены, Страница: 26 / 218

10. Place into service position
Note to Tower Users: The instructions in this
procedure are written based on the rack
model. Tower users may still use this
procedure. However, Tower users should
ignore specific references to rack-only features
such as rack doors, rack thumbscrews, and
rack-specific FRU orientation, etc.
Attention: When placing the model rack into
the service position, it is essential that all
stability plates are firmly in position to
prevent the rack from toppling. Ensure that
only one system unit is in the service position
at a time.
Remove two screws (A) securing the system
unit (B) to the rack.
11. Place into service position (continued)
While holding the system unit release latches
(A) down on both the left and right sides, pull
the system unit
(B)
out from the rack until the
rails are fully extended and locked.
Notes:
1. Ensure that the cables at the back of the
system unit do not catch or bind as you
pull the unit forward in the rack.
2. When the system unit rails are fully
extended, the rail safety latches lock into
place. This action prevents the system
from being pulled out too far.
18
Power Systems: IBM Power 550 Express (8204-E8A and 9409-M50) removal and replacement procedures