ZETRON 4000 Series, Installation Manual

Page: 140 / 418

Wireless Interface Options
140 025-9533Y
RPM is used with JAGUAR J725M radios or M7100 radios using J2R13 or newer
firmware.
ProGrammer is used with JAGUAR J725M radios or M7100 radios containing
J2R12
or
older firmware, or ORION radios.

To program the radio
1. Connect a programming cable between the rear of the radio and a serial port on the
programming PC.
2. Leave Zetron common control cable disconnected.
3. On the PC, start up the Harris ProGrammer software. Power up the radio control
head to get into programming mode.
4. Read the contents of the radio. When prompted for the radio type, select: Orion ,
M7100
, or
Jaguar 725M
.
5. All External I/O and Scanning should typically be disabled on fixed location
radios. This is especially true of the
System Scanning – Wide Area
mode. This
should never be enabled in a fixed location radio that shall be connected to a
console system. To disable these items:
a. In the
Options tab, Keypad Options menu:
Hookswitch Disable Scan (Parameter) = OFF (Unchecked)
Ramp Wrap (Parameter) = ON (Checked)
b. In the
Options
tab,
Scan Options
menu,
Conventional Scan Options
area:
Scan With Channel Guard (Parameter) = OFF (Unchecked)
c. In the Options tab, Scan Options menu, Universal Scan Options area:
Scan List (Parameter) = FIXED
P1 Programming (Parameter) = FIXED
P2 Programming (Parameter) = FIXED
d. In the System Scan Options menu:
Note If the Scan Add and Scan Delete buttons are to be used at the
IntegratorRD console, then the above parameters cannot be set to
the FIXED parameter value ( Scan List , P1 Programming , and
P2 Programming
). They must be configured according to the
user’s application desires instead.