ZETRON 4000 Series, Installation Manual

Page: 278 / 418

IntegratorRDPS Programming
278 025-9533Y
Associating an Aux. Output with a Standard Aux. Input
The field labeled “On input, output to Aux Output” is used to activate an output when the
input becomes active. Choose the desired output from the drop-down list of available
outputs.
Enabling the Alarm Display (Standard and Intercom Inputs)
The Alarm Input Mode field allows you to select if and under what conditions an input
displays an alarm message on the console screen. There are four alarm display options:
Table 97: Dual Alarm States
Input A, which must be an odd-numbered input, should be labeled as the alarm condition
input. Input B, which must be an even-numbered input, should be labeled as the Fault
condition input.
For this type of alarm, the inactive and active colors should be set to GREEN and RED
respectively. Then the display of the two inputs will be as shown in Table 98 .
Table 98: Dual Alarm Displays
Note If the outputs have not yet been defined, you will have to come
back to this point later to choose the output.
None The input will not cause an alarm message display.
Active The input will display an alarm message when the input transitions
from inactive to active.
Inactive The input will display an alarm message when the input transitions
from active to inactive.
Dual This special type of alarm input requires that two consecutive inputs
(Input A and Input B) present the alarm status shown in Table 97 .
State Input A Input B Condition
1 Inactive Active No Alarm/No Fault
2 Active Inactive Alarm
3 Active Active Fault
State Input A Input B Condition
1 GREEN GREEN No Alarm/No Fault
2 RED GREEN Alarm
3 GREEN RED Fault