ZETRON 4000 Series, Installation Manual

Page: 203 / 418

203
Using CPSW
Pre Emphasis. If you are uncertain, leave De Emphasis disabled unless the
reception of human voice sounds unnatural.
11. If you have additional channels to configure, click Next or Previous and repeat
this procedure.
12. If you are finished configuring channels for now, click Done .

To delete or clear a channel’s configuration
There are two ways to delete a channel’s configuration:
a. If you want to delete a channel’s configuration but retain the channel name,
change the
Channel Type
to
No Control Type Selected
.
b. If you want to delete a channel’s configuration including the channel name,
click
Delete
or change the
Channel Type
to
Undefined
.
Paging Format Configuration
Each paging format to be used in the Model 4018 and 4118 consoles must have certain
parameters unique to that format defined and must have a leading digit assigned to it.
There are 14 leading digits available to be assigned among the nine different paging
formats the console is capable of generating (some of which are optional). This allows the
console user to select which type of page to transmit by preceding each page with its
assigned leading digit.
If only one paging format is programmed (only one leading digit has been assigned), the
page is keyed in directly and no leading digit is necessary (or allowed). The console
already knows what type of page it will be.
Multiple variations of the same paging format can be programmed into the console by
assigning each one its own unique leading digit. For example, leading digits 3, 4, and 5
might each be assigned to the DTMF paging format but with different on/off timing
defined for each of the three formats.

To assign and configure a paging format for a leading digit
1. Click Edit, System Configuration, Paging Format Configuration .
2. To select a leading digit to configure, click on the leading digit or click
Prev. Digit
/ Next Digit until it is selected.
3. Select the
Paging Format
.
A number of configurable settings are displayed based upon the paging format that
was selected.
4. Configure the paging format settings. In general, you need to match your particular
or desired radio setup.
Notes for certain paging formats:
Note
When programming Instant Call Key paging stack(s), a leading digit
is always required.