IntegratorRDPS Programming
270
Coded Speech Control
(Tone Cards Only)
To use Private Line (PL), disable
Coded Speech
. Private lines can then be
configured.
To use Digital Voice Privacy (DVP), enable
Coded Speech
. Tone remote
channels can be configured to send tone remote functions to enable/disable
encryption at the base station and to send either dual- or single-function tone
sequences with a transmission.
Hook Flash
(If
Phone
is selected)
Sets the duration of the Hook Flash generated when the Hook Flash button is
pressed for this channel.
Base Station
Configuration
(DC or Tone cards only)
The Base Station Configuration field allows you to define the number of
transmitter and receiver frequencies that your multi-frequency base station
supports. This field is entered in the form of TxRy, where x is the number of
transmitter frequencies and y is the number of receiver frequencies. Acceptable
values for x and y are between 1 and 16. It is not necessary that x and y be the
same. The following are examples of valid entries:
T1R1 T2R1 T4R4
To configure frequencies and functions, see
Specifying the Frequency Control
Private Line
(Tone Cards Only)
To use Private Line (PL), disable
Coded Speech
. Private lines can then be
configured.
Tone-remote channels can be configured to support control of up to eight
Private Line or Channel Guard modes. Valid numbers are 0 and 2 through 8.
To configure PL control functions, see
Specifying the PL Control Functions
DVP Coded/Clear
(Tone cards only)
Allows the user to define the Digital Voice Privacy Coded and Clear
remote functions and the transmit mode.
Specifying the DVP Control Functions
Page Settings
During paging, a keyup delay can be specified that will delay the time from
keyup to the start of the page. The keyup delay is entered in milliseconds. Valid
range is 0 - 6000 ms.
Paging tones sent on channels with De-Emphasis enabled will be de-
emphasized unless they are being sent as a simulcast including at least one
channel without De-Emphasis.
Repeater Control
Enable
Repeater Control
if this base station includes a repeater, otherwise
clear the box.
If repeater control is enabled, the labels to be displayed and the functions
performed must be entered when the repeater ON/OFF keys are pressed. The
first field is a 1-, 2-, or 3-character identifier that shows the repeater condition.
The second field is the tone or current signal used when the console repeater
ON/OFF keys are pressed.
ANI Mode
ANI Type
There are several different formats of ANI that may be selected. The different
formats change the response of the console to receiving an ANI.
See
5/6 Tone Parameters
(If
5/6 Tone
selected)
See
Parameter/Area
Purpose
Summary of Contents for 4000 Series
