ZETRON 4000 Series, Installation Manual

Page: 351 / 418

Overview
351
Installation Verification
Overview
This chapter provides a procedure to follow that verifies a Series 4000 installation will
operate properly. If you haven’t already done so, first see System Check on page 173 and
perform the procedures there. The procedures in that chapter check base-level
functionality required by the procedure in this chapter.
Procedure

To perform installation verification on a Series 4000
1. Select a channel and transmit with the main transmit button on the audio panel.
(4118 or 4217b). Repeat the key up using the foot pedal, the handset button, or any
other PTT buttons. Ensure the selected radio keyed up with all transmit methods.
2. Select each channel in turn and key it up using your preferred transmit button.
Ensure each channel keys up properly.
3. With the headset/handset unplugged, ensure receive audio on the selected channel
is coming from the select speaker (typically the left speaker). All other audio
should be coming from the unselect speaker (typically the right speaker.)
4. With the headset/handset plugged in, ensure the selected channel audio is heard in
the headset, and all other audio is still in the unselected speaker.
5. [For multi-channel radios only] At the console, select a channel, then change the
frequency (F2...F3...F4 and so on). Ensure the radio is changing frequencies as the
frequency is selected. Repeat for each multi-channel radio.
Tip If you do not understand how to perform any of these steps, see
Series 4000 Communication Control System Operation
(P/N 025-
9535).