ZETRON 4000 Series, Installation Manual

Page: 272 / 418

IntegratorRDPS Programming
272 025-9533Y
Specifying the DVP Control Functions
The Coded/Clear label is a 1- to 7-character identifier displayed on the console when the
Coded/Clear
button is pressed. The Coded/Clear function is a tone signal used when the
console Coded/Clear key is pressed.
Click in the function field. A list of buttons labeled with the available tone frequencies
displays. Click the desired frequency.
If
Positive Mode
is enabled, a dual function tone sequence, containing the coded/clear
function and RF frequency selection tones, is sent. If positive mode is disabled, a single
function tone sequence, containing only the RF frequency selection tone, is sent.
Selecting the ANI Mode
The method of ANI operation is selectable on a per-channel basis. The IntegratorRD
workstation supports two modes of ANI decoding: Reverse Selective Calling (RSC) and
PTT ID. For RSC mode, there are three types: DTMF, 5/6 Tone, and SS1A. For PTT ID
mode, there are seven types: DTMF, 5/6 Tone, GE Star, MDC-1200, Zetron iRIM Type A,
Zetron iRIM Type B, and SS1A. See Table 95 .
Table 95: ANI Modes for IntegratorRD Workstation
In the RSC mode, the Primary and Secondary destination addresses are used to filter
incoming sequences. Channels with ANI Transpond enabled will activate transpond tone
following the receipt of a valid ANI decode.
For PTT ID ANI, the destination addresses are ignored and the most recent ANI displays.
As subsequent ANIs are received, the older entries are “pushed” into the background
buffer. Six ANIs are maintained in a revolving buffer. PTT ID ANI also provides detection
of “emergency” ANI and related alerting functions.
5/6 Tone Channel Parameters
Figure 54: 5/6 Tone Parameters
Mode Call Format * Description
RSC CCCCAA...A Standard Reverse Selective Calling
PTT ID AA...A Standard PTT ID
*
CCCC is a fixed length console address specified by the Primary and Secondary address.
AA...A is a variable length calling unit identifier.
AAAA is a fixed length calling unit identifier. The length is selectable.