ZETRON 4000 Series, Installation Manual

Page: 209 / 418

209
Using CPSW
Position Panel Layout
The layout of button panels can vary from position to position.

To configure a position’s panel layout
1. Click
Edit, Position Configuration
.
2. Use the up and down arrows next to the Position number to select the position to
configure.
3. Click Position Layout .
The Position Panel Layout dialog box opens.
4. Configure the panels according to the actual hardware in use at this position.
5. When finished, click
Done
.
Key Definitions
Each panel that is configured in the position layout has a button that appears in the Key
Definitions area. Panel 0 also has a button for configuring spare inputs.

To choose a panel for configuring keys
1. Click
Edit, Position Configuration
.
2. Select a panel by clicking on its button.
After selecting the appropriate panel, you will see a “key map” of the particular
panel that you are configuring. The layout of the key map matches the physical
layout of the keys on the actual panel.
3. Use the following procedures to define keys.

To erase key definitions
1. Click on
Erase
.
2. Select all keys to erase by clicking on them. Deselect keys by clicking on them
again. Selected keys are blue. Undefined keys cannot be selected for erasure
because there is nothing to erase.
3. Click
Apply
.
4. Click Yes to confirm.
Tip Choosing a panel affects the panel choices that follow, so configure
panels in numerical order (Panel 0 through Panel 3).
Note If you need to configure a Model 4116B, select M4118 . The
firmware and programming for these two models are identical.