ZETRON 4000 Series, Installation Manual

Page: 286 / 418

IntegratorRDPS Programming
286 025-9533Y
Table 100: MDC-1200 System Parameters window
Parameter/Area Purpose
Tone Setting
If
Side Tone
is enabled, the workstation sends a tone for the duration of MDC-
1200 signaling.
If
Talk Beep is enabled, the workstation sends a go-ahead-to-talk beep when
MDC-1200 signaling is completed and voice transmission may begin.
Both tone settings are ignored if the transmitting channel has voice delay
enabled.
Selective Call Mode
If set to toggle, after selective call is activated, it stays active until the selective
call button is pressed again. If set to momentary, after the transmission is
complete, the selective call function is automatically deactivated.
Emergency Mode
In normal mode, when an emergency alert is sent, the workstation provides
visual feedback, whereas in silent mode, it does not.
If an Emergency Channel and (optionally) Frequency are programmed any
Emergency Alert will be sent on this Emergency Revert Channel and
Frequency. If no Emergency Channel is programmed the currently selected
channel is used.
Confirmation The workstation system may be configured to require a confirmation before
sending a Call Alert, Emergency Alert, Emergency Acknowledge (manual
initiation only), Radio Check, Status Request, Radio Disable, Radio Enable,
Radio Monitor Enable or Radio Monitor Disable. When required the
confirmation is requested after the subscriber and function is selected. It
summarizes these two selections.
For a description of these commands, see
Confirmation (MDC-1200
Commands)
on page 287.
Password
If a password is defined, the dispatcher must enter the password to confirm
certain commands such as enabling and/or disabling the Radio and Remote
Monitor.
Emergency Channel
Select the channel where emergency calls should be routed to. Only MDC-
1200 channels are displayed here.