Xerox Nuvera 100, Service Manual

Page: 86 / 304

2-8
iiLINX™ Solid Inkjet 100 Service Manual
4,000: PC Processor Control Supervisor (continued)
Error Codes
Front Panel
Display Software Error Code Meaning
4,015.45
(0x240f)
PC_DEV_FAULT_HEAD_ADJUST_TIMEOUT
pc fault: head adjust timeout Timeout during head adjust. A 20 minute timer
elapsed before the exit head adjust command
was executed. The only recovery possible is to
cycle the power switch.
4,016.46
(0x2410)
PC_DEV_FAULT_HEAD_NV_FORMAT
pc fault: printhead NVRAM format This head’s NVRAM contains a format of data not
supported by this version of firmware. The head
or firmware must be replaced.
4,017.47
(0x2411)
PC_DEV_FAULT_AMBIENT_TOOCOLD
pc fault: tempt too cold Ambient temperature is less than 10 degrees
Centigrade. The printer cannot be warmed up
under these circumstances.
4,018.48
(0x2412)
PC_DEV_FAULT_LATE_CLEAN_REQUEST
pc fault: late clean request Printhead temperature has dropped below the
head-clean-needed threshold. This condition
occurred after the warmup sequencer had
determined a head clean operation was not
needed.
4,020.41
(0x2414)
PC_DEV_FAULT_FTTR_HEADCAP
pc fault: FTTR head cap contact Declared when the printer is booted in FTTR
mode and the head/cap contact flag is set in
NVRAM. The printer cannot run in FTTR mode
with head/cap contact because it would be
unwise to separate the two when cold. Service
requested that this be a device fault in order to
bluntly alert the service person to the condition.
4,021.42
(0x2415)
PC_DEV_FAULT_FTTR_DIRTYDRUM
pc fault: FTTR dirty drum Declared when the printer is booted in FTTR
mode and the drum is dirty. Reasoning that
cleaning the drum when very cold could increase
the chance of gluing media to the drum surface
and creating an ugly mess around the stripper
fingers. Service requested that this be a device
fault in order to bluntly alert the service person
to the condition.
4,022.43
(0x2416)
PC_DEV_FAULT_INK_OUT_DURING_FLUSH
_TIMEOUT
pc fault: ink out timeout Timeout during head flush for ink yellowing. The
printer ran out of ink and a ten minute timer
elapsed before more ink was added. The only
recovery possible is to cycle the power switch.