Xerox Nuvera 100, Service Manual

Page: 234 / 304

6-44
ii LINX™ Solid Inkjet 100 Printer Service Manual
5. At the right side of the printer, slide the metal vacuum hose out
of the cap/wipe/ purge unit.
6. Unlatch the timing belt lock of each belt to free each belt.
When installing new belts, reverse these steps and attach each belt so
that the pointer on each belt lock points at the index mark on the
printer side frames. Tighten each lock to its fourth tooth as
illustrated. Perform the belt alignment adjustment using procedure in
Chapter 4 to ensure the belts are aligned and that the cap/wipe/purge
assembly will correctly seal against the printhead faceplate.
Unlock
Index mark
on right
frame
Belt lock
Right
cap/wipe/purge
assembly belt
Left belt lock:
align pointer
between
two index
marks
For new belt,
break off
actuator
on left-side
belt lock
Fan
Latch
Lock
Leave gap
between latch
and belt
tensioner
840-4-29
Figure 6-28. Removing Cap/Wipe/Purge Timing Belts