Xerox Nuvera 100, Service Manual

Page: 199 / 304

Removal and Replacement 6-9
Removing the Exit Door and Exit Roller
1. Remove the right cover.
2. Remove the left cover.
3. At the right side of the printer, remove the cap/wipe/purge
electric clutch. Use a small, flatblade screwdriver to release
the clutch from the shaft. Also remove the right-side keyed,
white plastic bushing.
4. At the left side of the printer, release the tension on the exit
roller drive belt. Slip the belt off the exit roller drive pulley.
5. Use a small, flatblade screwdriver to release the drive pulley
from the exit roller shaft. Also remove the left-side keyed,
white plastic bushing.
6. Remove the exit roller, lower exit guide and exit door from the
printer.
7. Unclip the lower exit guide from the exit roller.
8. Slide the exit roller out of the exit door.
Reverse these steps to install the exit door.