Xerox Nuvera 100, Service Manual

Page: 243 / 304

Removal and Replacement 6-53
Installing RAM DIMMs
The printer accepts two SDRAM DIMMs which are 64 Mbyte in size.
The printer recognizes any acceptable size SDRAM DIMM in any
RAM DIMM slot. Use the following steps to installing new RAM
DIMMs.
1. Power down the printer. Leave the power cord plugged in to
provide a ground path for static discharges.
2. Loosen the two rear panel screws securing the main board.
Slide out the main board.
3. To release an installed RAM DIMM, spread the latches
securing each end of the DIMM in the connector.
840-4-37s
SDRAM DIMM
DIMM 1
DIMM 2
Figure 6-34. Locating RAM DIMMs
4. To install a RAM DIMM in the keyed DIMM connector, insert
the DIMM until it locks in place. When properly inserted, a tab
on each end of the connector slips into a notch on each end of
the RAM DIMM.
5. Reinstall the main board into the printer.
6. Reconnect the host interface cables. Turn on the printer and
print the start page to verify the memory installation.