Xerox Nuvera 100, Service Manual

Page: 227 / 304

Removal and Replacement 6-37
6. Engage the yoke span and the un-mounted yoke leg by rotating
the end tabs of the span to fit through the large rectangular
hole of the leg. Orient so the parts are coupled perpendicular
to one another.
7. Insert the free span end of this assembly into the upper leg
opening and orient to couple them. Take case not to wipe
lubricant out of the span. The pocket should only come into
contact with the end of the nose cone.
8. Rotate the yoke assembly downward over the nose cone and
latch the lower leg to the stiffener tab. Rotate the stop collar as
required to permit attachment of the leg during this
installation.
9. Install the X-axis motor. Take care to fully seat the motor
positioning boss into the stiffener panel.
10. Install the motor bracket
11. Connect the X-axis motor wiring harness.
12. Perform the X-axis Scale Adjustment procedure.
Y-axis Belt Drive Assembly
1. Remove the right cover.
2. Disconnect the wiring harness leading from the front panel to
the right I/O board passing beside the Y-axis belt drive
assembly.
3. Remove the drum fan.
CAUTION
Never loosen or remove the three screws securing the assembly
parts together.