Xerox Nuvera 100, Service Manual

Page: 88 / 304

2-10
iiLINX™ Solid Inkjet 100 Service Manual
7,000: Process Motor Error Codes
8,000: Cap Drive and Web Sensors Error Codes
Error Codes
Front Panel
Display Software Error Code Meaning
7,002.4x
(0x3c01)
PM_FAULT_PROCESS_MOTOR_STALL The process motor stalled during operation. This
has several possible causes, depending on what
the PM was connected to at the time of
operation.
7,003.4x
(0x3c02)
PM_FAULT_COMPOUND_GEAR_SENSOR_BAD No transitions are observed of the compound
gear sensor when the compound gear should be
turning. Perhaps the sensor is bad (it falls off
easily), or the PM to compound gear linkage is
broken.
7,004.4x
(0x3c09)
PM_FAULT_DM_CAM_SENSOR_BAD No transitions are observed of the drum
maintenance cam sensor. The sensor may be
bad or the DM cam may be jammed.
Error Codes
Front Panel
Display Software Error Code Meaning
8,001.44
(0x4401)
CAP_FAULT_HOME_SENSOR
cap fault: home sensor An expected transition of the cap home sensor
did not occur. The home sensor may be faulty, or
the cap motor may not be operating, or the cap
may be jammed and unable to move.
8,002.45
(0x4403)
CAP_FAULT_OVERCURRENT
cap fault: overcurrent An overcurrent fault has been detected. Either
the cap motor is shorted, the purge pump motor
is shorted, a solenoid is shorted, or the cap
stalled. (This fault does not actually occur
because the mechanism is loose. When the cap
jams, the motor skips over teeth.) Check the
hardware.