Xerox Nuvera 100, Service Manual

Page: 98 / 304

2-20
iiLINX™ Solid Inkjet 100 Service Manual
Table 2-2. Front Panel Status Messages (continued)
Status Message Solution
Close front cover to continue
The printer is stopped; close the front cover to resume
printing.
Close exit cover to continue
The printer is stopped; close the exit cover to resume
printing.
Close top cover to continue
The printer is stopped; close the top cover to resume printing.
Ink sticks jammed—Open and
Ink sticks under the top cover are not sliding properly. Open
close top cover to clear jam
and close the top cover to resolve the problem. If the problem
persists, jostle the ink sticks until there are no spaces
between the sticks.
Output tray full—Remove
The media in the output tray is either jammed or the tray
printed pages to continue
is filled to capacity. Remove hte printed pages to continue.
Out of ink—Open top cover.
The printer is stopped. Open the top cover. Add ink. Close the
Add ink.
top cover.
Add ink. Close top cover.
The printer is stopped. Add ink. Close the top cover.
Drawer A locked—Close front
Waste Tray B is cooling; Close the front cover and wait two
cover to continue
minutes for Drawer A to be unlocked.
Paused
The printer is in pause mode. You may add media or ink
safely. Press Resume to continue.
Printing—Pause Pending
The printer is finishing the current page. It will pause when
this page completes.
Media jam—Retry manual feed
Remove media. Verify that media used is within specifica-
tions. Use both hands to reinsert sheet until it feeds and
stops.
Media jam—incorrect media
Remove jammed media and close the exit cover to resume
size—Open exit cover to clear
printing.
Media jam—Open front cover
Open the front cover and remove media to resume printing.
to clear
Media jam—Remove media tray
Remove jammed media and reinsert media tray.
to clear