Xerox Nuvera 100, Service Manual

Page: 162 / 304

4-18
ii LINX™ Solid Inkjet 100 Service Manual
it is flush with the head tilt arm, and then tighten the two screws.
The bracket must be flush with the tilt arm.
0388-31
0388-36
Upper chassis screw
Push forward here
so bracket is tight
against chassis
screw and hex screw
Push forward here
so bracket mounts
flush with head tilt arm
Cutout for hex screw
Figure 4-6. Mounting the Digital Indicator Gauge.
Zero the Digital Indicator Gauge
If the digital indicator gauge is not zeroed properly, it will produce
unstable readings. To zero the gauge:
1. Place your thumb on the gray Origin button.
2. Place your index finger underneath the gauge.
3. Press and hold the Origin button until the gauge zeroes, being
careful to support the gauge with your index finger.
4. To test the stability, move the head tilt arm back and then
forward several times. The gauge should return to zero each
time the head tilt arm is moved forward. Do not move the tilt
arm by the bracket mounted on it. This will cause the arm to
flex and your readings will vary.