Waters ACQUITY CM-30S, Overview And Maintenance Manual, Page: 77 / 146

Replacing the column-outlet tubing in a CM-30S installed in an APC system
October 7, 2014, 715004178 Rev. B 77
• 1/4-inch open-end wrench
• T20 TORX driver
Note:
Illustrations in the following procedure depict changing column-outlet
tubing on the left-hand side of the column compartment. The illustrations also
apply to changing a column-outlet tubing on the right-hand side of the column
compartment.
To remove the column-outlet tubing:
1. Stop any running mobile phase before replacing the column-outlet
tubing.
2. After allowing sufficient time for the oven to cool, open the outer door of
the CM-30S.
Outer door
handle