EUROBLOC
SERVICE MANUAL FOR HOIST
77/212
This document and the information contained herein, is the exclusive property of Verlinde S.A.S. and represents a non-public, confidential and proprietary trade secret that
may not be reproduced, disclosed to third parties, altered or otherwise employed in any manner whatsoever without the express written consent of Verlinde S.A.S.
Copyright © (2013) Verlinde S.A.S. All rights reserved.
06/2015
Reassembly
1
2
Install the washer sleeves (11) on the screw. Put the bearings
(10) on the sleeves (11), place the washer on the bearings
(10), and lock it with a nut.
Fasten the screw with the bearing (10) to the torque arm (8).
3
4
Clean and lubricate the bearing (10) surfaces on both ends of
the pressure roller (1). Press the correct torque support to the
correct end of the guide roller with a rubber hammer.
Brush grease on the sleeve bearings (9) and place them into
the torque arms (8). Push bolts with washers through the
sleeve bearings.
Note: Roller guide installation direction depends on the hoist type.
5
6
Place the pressure roller (1) between the hoist end plates.
Push the locking bolts through the frame. Make sure the
clearance (t) between the torque arm and the frame is max. 2
mm.
Place the bolts (6) into the housing (7). Oil the bolt heads
lightly with installation oil. Install the housing to the end plates
and lock them into position with the bolts, nuts, and washers.
