EUROBLOC
SERVICE MANUAL FOR HOIST
184/212
This document and the information contained herein, is the exclusive property of Verlinde S.A.S. and represents a non-public, confidential and proprietary trade secret that
may not be reproduced, disclosed to third parties, altered or otherwise employed in any manner whatsoever without the express written consent of Verlinde S.A.S.
Copyright © (2013) Verlinde S.A.S. All rights reserved.
06/2015
1
2
Check the gap between the wheel flange and the flange of the
beam. If necessary, adjust the side plate (5) of the trolley
inwards until there is a gap of approximately X = 3…5 mm
between the wheel flange and the flange of the beam.
Check that the position of the trolley is adjusted so that the
hook is hanging below the centerline of the beam.
7.3.2 Trolley buffers
The hoisting trolley is provided with rubber buffers. Some models are equipped with buffer extensions.
7.3.2.1 Maintenance of trolley buffers
1
Check that the hoist buffers (1) bump into the runway end
stops (2) or buffers of other trolley.
Check that the buffers (1) and runway end stops (2) are in
good condition. Replace broken buffers.
If buffers are worn or broken, investigate why buffers are
used. Buffers are not operational limits.